How to get your LED mask started
To get you started let's check that you have the below items:
> Silicone flexible LED face mask
> Removable eye protection
> Power supply and country specific adaptors
> Controller
> USB connector
> Velcro head straps
> Carry bag
How To Use Guide
Step 1: Cleanse the skin to remove any traces of skincare and makeup.
Step 2: Insert the USB cable from your LED mask into the top of the controller.
Step 3: Place the device on the face, secure with the Velcro straps and switch on the controller.
Step 4: Select your treatment mode on the controller. The device switches off after a ten minute treatment time. You may stop the treatment at anytime by pressing and holding the controller button down.
Step 5: Remove your mask, apply your normal serum, moisturiser and sunscreen.
Step 6: Clean the mask using a water based wipe or a damp clean cloth.
* We always recommend checking the contraindications and performing a sensitivity test 24hrs prior to your first treatment. Please refer to your user manual.
How to charge your LED Mask
This device uses a Lithium ion polymer battery. When in charging mode the LED mask will not illuminate.
Before use it is important to fully charge your LED mask battery/controller.
To charge your controller use the additional cable and insert the USB-C cable into the controller and insert the USB connector into adapter provided.
While charging, the indicator will flash green and turn solid when fully charged.
The device will take around 6 hours to charge, each charge is sufficient for approximately 10 treatments.
Troubleshooting
Need help? It's normally quick and easy to solve.
LED mask not turning on.
> Make sure your LED mask is fully charged.
> Press and hold down the controller button for a few seconds until the LEDs illuminate.
> Ensure the USB-C and USB ends of the charging cable are connected properly.
> Use an alternative outlet to help identify and check any charging problems.
LED Mask is turning off after 30 seconds.
The controller battery charge may be low and we recommend charging the controller fully and try again.
For anything else.
DO NOT attempt to investigate or modify the device in any way. The device has NO parts you can repair yourself.
Please contact Trudermal customer service at team@trudermal.com.au for further assistance.
Care & Maintenance
Clean your LED device after each treatment with a water based wipe or damp clean cloth.
Store your LED mask at room temperature in dry condition using the carry bag provided.
Avoid storing the device in dusty condition, direct sunlight or in damp and humid conditions.
